Bambu Lab H2D laser: preparing photos and files outside Bambu Studio

The laser module of the Bambu Lab H2D is controlled through Bambu Studio, with the printer's own firmware. So the job is always sent from Bambu Studio, and Vextrify does not connect to the machine. Vextrify is useful one step earlier: it prepares photos for the material, cuts out backgrounds, turns logos into clean SVG outlines and lays out the job, then exports PNG and SVG files that you import into Bambu Studio.

• Bambu Studio sends the job
• Vextrify does not connect to the machine
• Vextrify prepares and exports PNG and SVG files

Photos decide most engraving results. In Photo Studio you pick one of 12 material profiles, which sets starting values for brightness, contrast and gamma, compare ten dithering methods plus grayscale in a live preview, and export a PNG at the size you will engrave. When you import an already-dithered PNG, check that the maker's software does not add its own dot pattern on top, and test once on scrap.

• 12 material profiles as a starting point
• Ten dithering methods compared in the preview
• Avoid a second dot pattern on import

The background remover isolates a subject as a transparent PNG, and transparent areas stay unengraved. The vectorizer and the contour tool turn logos and outlines into SVG, which most maker software can use for cutting or scoring. Text and QR codes can be placed in the same layout before export.

• Transparent PNG cut-outs
• SVG outlines for cutting and scoring
• Text and QR codes in the layout

Save a setting that worked as a recipe, and Batch applies it to a folder of photos and returns one ZIP. Import the files into Bambu Studio, set speed and power there from your own material test, and run the job as usual. Customer photos are processed on your own computer by the local photo tools, without a per-image fee.

• Recipes and Batch for repeat orders
• Speed and power stay in Bambu Studio
• No per-image fee for local tools